Tapping chucks for synchronisation HSK 63 - M3-M12 - 100 | ER 16 | Mini

Tapping chucks for synchronisation HSK 63 - M3-M12 - 100 | ER 16 | MiniApplication: For machining centres with synchronous spindle. Note: Synchro tapping chucks compensate synchronisation errors. Minimal length compensation on compression and expansion balances very small pitch differences between synchro spindle and tap, which can cause high frictional forces on the thread flanks. A possible increase of axial force during the tapping process is reduced to a minimum. Suitable for internal coolant. Coolant pressure up to

With fi ne adjustment carriage to feed the slider finely

Minimum internal diameter measurement capability of:

is prevented from attaching itself by vacuum

For sealing the spindle of the turret

Taper angle tolerance < AT 3 according to DIN 2080

For retaining screw DIN 6367

5 with h4-tolerance and Ø 6 – Ø 32 with h6-tolerance3

- reading 0

Trolley (empty) for max

Made of precision ground hardened stainless steel

6 µm radial run-out with a 5 µm clamping nut

For tools with taper shanks DIN 69871 and JIS B 6339 (MAS-BT)